Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Troll
 - June 04, 2013, 12:43:33 PM

The wiring diagram and the service manual are not helpful. Shows it's a 2 wire switch, on or off.....There should be a connector under the engine with the two wires in it. I would first try disconnecting it and see if the engine runs, and if it doesn't , jumper across the harness side connector and see what happens. I suspect the two poles must be connected, but there is NO information in the manual....

Posted by Troll
 - June 04, 2013, 12:33:55 PM

If the engine runs until you pop it in gear, and then stops..the sidestand switch is probably the culprit. I'll look at the wiring diagram for it and get back to you.

Posted by Anti-hero
 - June 04, 2013, 10:15:33 AM

Oh I see the cable that runs behind the sidestand? How do I go about this?

Posted by Anti-hero
 - June 04, 2013, 10:06:55 AM

Sidestand switch?

Posted by Troll
 - June 04, 2013, 10:03:35 AM

Sidestand switch? Always hated those stupid things....

Posted by Anti-hero
 - June 04, 2013, 10:01:48 AM

So my bike starts changed the oil and spark plugs on Saturday and it rode fine until this morning... Bike starts and everything but when I go into first gear and I'm about to take off it shuts off... I let warm up and everything but it jus stalls when trying to take off...
Help this is my only ride much help appreciated... Thanks.

SMF spam blocked by CleanTalk