We limit access by GUESTS to protect our members from spam, hacks and trolls. Please register to gain access to all our resources.
I have a very similar problem....great job figuring it out. What part numbers did you have to order?
well folks.... i have a good clutch now! no longer is grabby and creeping forward. the pull rod was indeed broken where it slides in the shaft. i'll post pictures after i finish touching up the paint on the frame
well, i found what i believe is the problem. the pull rod id broken where it slides in the clutch hub.it pulls the plates,but not at the straight angle it should be. i'll have to order a new rod and gasket to find out if i am a good guesser.
i have had a issue with the clutch not disengaging. i thought it was stuck plates from sitting. today, i removed the clutch cover then the plates. nothing stuck. adjusted the cable several times (top & bottom adjusters). anyone had an issue with the release arm? i am going loopy thinking of what may be wrong.
Page created in 0.088 seconds with 12 queries.