Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by chief
 - March 28, 2010, 16:23:01 PM

Thanks.

Posted by 1999 Drifter
 - March 28, 2010, 16:12:44 PM

 ;D ;D

Posted by motosickle
 - March 28, 2010, 14:18:10 PM

well folks.... i have a good clutch now! no longer is grabby and creeping forward. the pull rod was indeed broken where it slides in the shaft. i'll post pictures after i finish touching up the paint on the frame

Posted by motosickle
 - March 16, 2010, 19:49:36 PM

well, i found what i believe is the problem. the pull rod id broken where it slides in the clutch hub.it pulls the plates,but not at the straight angle it should be. i'll have to order a new rod and gasket to find out if i am a good guesser.     

Posted by motosickle
 - March 15, 2010, 19:36:21 PM

 i have had a issue with the clutch not disengaging. i thought it was stuck plates from sitting. today, i removed the clutch cover then the plates. nothing stuck. adjusted the cable several times (top & bottom adjusters). anyone had an issue with the release arm? i am going loopy thinking of what may be wrong.

SMF spam blocked by CleanTalk