Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by marshalldoll
 - March 15, 2013, 13:25:35 PM

The bar actually goes under the large washer. You may have to give the back of the washer a little bend upwards so that the bar on the Corbin seat goes under it. Then it will sit right for you!!
Dan

Posted by nhtrikes
 - March 15, 2013, 11:06:52 AM

I just received my 2-up seat from Corbin last week for my 1500 and got the support bracket and passenger backrest attached. Beautiful seat by the way, Corbin does a nice job. Huge dip in the saddle, reminds of an English horse saddle. Anyway, I noticed the front where the single seat has a slot that slides onto the bolt on the frame ,the Corbin seat does not. It has a flat bar and two bumpers or feet on the front of the seat that apparently just rests on the frame or tank. Is this correct? I know it has four other attachment points, two where the single seat attaches and two aft., support bracket to frame. Just want to make sure I got it right so's I don't loose my honey off the back.  Thanks!!!

Take care,

Pete . . .

SMF spam blocked by CleanTalk