Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by teamster6
 - March 14, 2013, 23:56:17 PM

greenbarn thats correct. However I dont know if I can go under the rubber seal on the tail light or not as everything is tight but will see.

t6

Posted by greenbarn
 - March 14, 2013, 21:14:28 PM

I would think, if I understand what you're doing here, that you would want to wird those into the tail light.  Isn't that the closest easiest place?  Do I understand correctly that you want these LEDs to come on as marker lights, right?

Posted by teamster6
 - March 14, 2013, 20:30:54 PM

Wow I am guessing I did not get any replys because I wasnt smart enough to figure out that the plate bracket did not come with led lights installed in it so nobody could figure out what in the world I was talking about.

Somebody altered this one. I have one comming from Chief and I will try and install the led lights off this one.

Anybody have any idea where would be a good place to wire them in?"

Posted by teamster6
 - March 08, 2013, 13:21:38 PM

"Well on the bike I purchased somebody modified the license plate bracket and removed the original. Thanks to Chief I have the mount and plate holder and I was lucky enough to find the side reflectors which are lighted. Can anybody tell me where the side reflectors wire into???

I have to go out and look again and see if they wire into the tail light itself or are on a separate line.

t6 

SMF spam blocked by CleanTalk