GUEST? Registration opens up many more resources which are not available to guests. Registration is free, we never sell or give others access to your information.
Quote from: pcarrell on March 01, 2013, 15:22:53 PMBut isn't the chrome outer tube on the Nomad basically a heat shield around a much smaller pipe. If the V&H pipes are solid tube without an outer shield they will get much hotter than the Nomads.This is a factory stock 2009 Kawasaki Nomad......
So, I'd say you're probably looking at somewhere around 2 inches.
A heat shield mounted on the bottom of the bag might help but you will need a space between the bag and the shield for air flow. I'm building a hot rod and have the same issue between the battery case and the exhaust. I'm using a piece of bakelite for an insulator.
You could go to about an inch IF you put in a heat shield that doesn't touch either the bags or pipes. Tin would work well.
Regards,
This is a factory stock 2009 Kawasaki Nomad......

So, I'd say you're probably looking at somewhere around 2 inches.
I am in the process of doing the Vance & Hines longshots to duals mod as found in the mod tips section. I am also adding a set of fiberglass hard bags. I want to hang the hard bags low. My question to anyone who might know something about this subject is what is the minimum space I should leave between the exhaust and the bags on each side?
Thanks,
Brillo
Page created in 0.080 seconds with 12 queries.