GUEST? Registration opens up many more resources which are not available to guests. Registration is free, we never sell or give others access to your information.
Posted by John Hopkins
- January 30, 2013, 05:36:49 AMbeee -zittttd again - you can feel the vibration of the solenoid throwing and re-setting when you place your finger on the unit.
I'm not sure I understand this bit...You seem to be on top of most of this but..
are you putting your finger on the starter solenoid or the starter..
The starter solenoid or starter relay is under the seat or inside the right cover..depending on model..
If the solenoid is making that noise it is likely loose or has a loose connection, or it is poorly mounted and the noise is an arc to ground..
you can bypass the solenoid by running a thick wire directly to the starter motor from the battery +, this will cause the starter motor to run and eliminate all the rest of the circuit...don't leave it running for more than a second or two...
you don't need the ignition on...if it grinds or doesnt sound good you have a fault at the starter motor or the gears it connects to..
If that is ok..move back to the solenoid and bridge the two thick wires, that should do the same thing..
If it doesn't you have a loose wire from the solenoid to the starter motor or the battery to the solenoid.
I forgot to mention..this assumes the battery is good and the battery connections are both clean and tight.
John.
Posted by drifter-paul
- January 30, 2013, 00:54:00 AMRead the recent "won't start" topic, but I don't think it applies here.
After a year (camshaft, camchains/sprockets, MS clutch, fork oil, etc and a new paint job and pinstripping), my '99 1500 (140K) is back on the road (was).
Took it for a few rides, various short distances and different days, and then one 200 mile one. Had a beer and half hour later decided to go out again. Got 100 yards and she died. Brake lights/horn/indicators work. Tried starting again - console lights work as per normal, on then off - wait till console lights finished, then hit starter. Got a bee - zitttt noise from starter solenoid , so replaced that (with a second hand unit). She ran for a week than beee -zittttd again - you can feel the vibration of the solenoid throwing and re-setting when you place your finger on the unit.
Checked grounds for wires - clean , unpainted, connected and tight, no visible shorts.
Took starter motor out of m/c and auto electrician tested it - fine. He suggested bypass testing of existing wiring.
I was hoping it was a poor ground, or worn components in the starter, aggravated by sitting for a year.
Now I'm at a loss.
P.S. You don't need to drain the radiator to get the starter motor out. Remove the starter motor wire, and the single-wire switch on bottom of radiator. Undo two bolts on left holding starter in place, insert blade screwdriver on right side of starter and wiggle/pry to the left - settle starter motor on engine block/radiator. Undo bolt holding top of radiator to frame, move 1'' forward and up until s/motor drops into hand of assistant..