Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by 49Reo
 - July 27, 2012, 12:13:36 PM

If you go online, you can go to their site; phone them, they can walk you trough any issues. If you have access to a laptop, they can actually go through your laptop, and program your unit for you; you would need to hook your laptop up to the PCIII module. Also, the PCIII module requires ALL connections be done using the wires/connectors supplied; even the ground wire. If you hooked it up according to their instructions, then that shouldn't be the issue.  Try giving them a call; I had to get their help downloading their program to my laptop; for some reason, it wouldn't load. They went in to my laptop from their computer, did the set up, changed the mapping on the module, everything was good after that.

Hope this helps; keep us posted.

Regards and such,
49Reo

Posted by Paragon
 - July 27, 2012, 04:33:42 AM

I have installed a power commander 3, I have loaded the map for my pipes. The pipes are the only change. my throttle position is reading 100%, i have tried to set it but have been unsucessfull. The bike runs as bad (fowling plugs and runs rough) as it did before. this is why i thought the tps may be the problem.

Also I can not get the pc3 into manual adjustment by pressing the 3 buttons at the same time.

If someone has installed the pc3 on the Drifter 1500 and could help I would greatly appreciate it.

Thanks
Steve

SMF spam blocked by CleanTalk