Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Troll
 - April 29, 2012, 19:35:58 PM

I had to do it twice when I rejetted the carbs on my W-650...basically the same unit you have, times 2. It's pretty easy, but you should take the carb off and turn it up side down. Use a good quality 5/32" drill and go slowly. Once you get a hole through the cap, you can pop it out with a pick. I wound up setting my idle screws at 5 turns out....but your engine is VERY different. I copped this of the dynojet web site....

Posted by Boaski
 - April 29, 2012, 19:13:51 PM

Has anyone drilled out their low speed mixture screw cap & adjusted the mixture? My bike is definitely running lean just off idle. The cooler it is outside the worse it gets.

SMF spam blocked by CleanTalk