Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Troll
 - October 14, 2011, 19:45:48 PM

You are going to have to take the seat off, remove the battery hold down (do not disconnect the battery!!!!) and pull the controller up so you can access the connectors. On one end, the smallest of the connectors has no wires in it...you need to ground pin 37 to the battery with a jumper wire, then turn on the ign. switch and count the flashes...for each digit of the code, there will be one blink, followed by a 1 second break, followed by the next digit...like blink......blink blink....(that would be a 12)....then a 3 second interval and the code repeats 3 times, then if there are more it will blink again... like blink blink......blink blink blink blink.....that would be a 24, once you know the code, post it here and I can look it up for you and give you trouble shooting instructions. make sure you give it enough time to go through all the codes, in case there is more than one.

Posted by george
 - October 14, 2011, 19:05:21 PM

Help, went for a spin, felt like the clutch slipped then started backfiring, half ass run then not, had to baby it home , it would take off like hell then stop had to keep throttling like crazy to get home, plus FI light came on, any advice would be nice. 01 drifter 17000 miles no problem till today. 1500

SMF spam blocked by CleanTalk