Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by cochise
 - July 21, 2011, 22:14:14 PM

Awhile back on one of the forums there was a discussion about repairing fender holes with epoxy. It would be the same type of repair. Check the forums , I know it was on there.

Posted by chief
 - July 20, 2011, 13:35:15 PM

I have no experience with repairing these fenders, but I know they have been repaired. I know some folks have used the epoxy type repair kits. You might look for a repair company in your area as well. I will see if I can find any info on this for you.

Posted by Dobber
 - July 20, 2011, 10:00:30 AM

I had something kick up under my front fender and it caused a crack about an 1 1/2" long along the lower back side. Has anybody had good results with the epoxy type kits or any other method? The crack is clean with no gaps and thinking I may need to drill small holes at the crack ends to prevent the crack from growing.

SMF spam blocked by CleanTalk