Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by chief
 - June 13, 2011, 19:42:42 PM

Well, whatever the pressure before, it ain't that pressure now!

You have to use a lossless gage... the mini-pump by Progressive is the one to use... its a pump and gage and it won't spew your oil everywhere...

http://www.vulcandrifterriders.com/blog/?p=590

Here is some info:

- Raise the rear wheel off the ground to adjust pressure and make sure you have the same pressure in each shock.
- Use a loss-less pump only - like the one above.

-  Max air pressure is 71 PSI. Normal pressures 0 to 43 PSI.
-  Bike comes set at Atmospheric pressure intended for 150 lbs.

-  Higher the load or the worse the road are, the higher the pressure should be adjusted.

- 43 psi = Heavy Load / Bad Roads
-   0 psi = Light Load / Good Roads

- Shock Pre-set (1=soft ride, 4=stiff ride)

- 1 = Light load, soft ride, good road conditions, low speeds
- 4 = Heavy load, stiff ride, bad road conditions, high speeds.

Personally, I replaced my air shocks with Progressive 440's... overkill now that I ride solo on the Drifter, but at the time needed it for two-up and luggage. Progressive 412's are used by some Drifters as well.

Posted by rawv
 - June 13, 2011, 15:06:41 PM

Ok I need some help here... I ride a 99 1500 drifter ...so we went riding yesterday and with a total of 350 LBS. ( her and I ) and no accessories  I noticed that after hitting a couple bumps we hit hard and bottomed out...this is the first time I've ridden the bike two up since I bought it last fall...anyhow I have the preload set at 4 and checked the air pressure and got a reading of 35 lbs. and oil sprayed everywhere what a mess ...they say in the owners manual don't use a tire pressure gauge because they are inaccurate ...so my questions are 1)   how many psi  should I run in the shocks 2)  if they say not to use a tire gauge then what kind of gauge and pump do you use and 3) how do you get around oil spraying everywhere when you use the air valve to check the pressure.  Thanks Rick

SMF spam blocked by CleanTalk