Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Troll
 - June 12, 2011, 08:43:44 AM

  The problem with the forks on the Kawasakis, in general, is that they have no fork oil drains. The only real good way to get all the old fish oil out is by removing and inverting the fork, and leaving it for a while. Factory manual recommends disassembly and draining the lower legs. I did this last winter, putting in the P.S. springs...what a difference...I used Dexron 3 auto trans fluid in the fork, ( I know what it says in the manual, but I've been using atf for more than 30 years in all my hydraulic forks, never been disappointed, yet) set to the specified level (The instructions with the springs are ok, and will give you a decent idea) I have about 3500 miles on so far this year, and everything is working great. As far as the noise you are hearing, check to see if the rivets holding your front fender to the internal bracket haven't gotten loose, especially the top ones. I replaced my upper rivets 2x in 12,000 miles due to rattle noises. When I bought the bike, the fender was very sloppy, and then 12,000 miles later, I noticed that the fender was loose on the top, again. I put in 6mm stainless button head screws in place of the top rivets. I tapped the inner bracket for the screws, and then put a little blue loc-tite on the threads, ran them in tight, put a little more blue on the threads, put a 6mm nut on them, tightened that, and then ground the part of the screw that was sticking out off flush with the nut. The whole thing is the same height as the rivet, and a lot stronger.

Posted by griz01
 - June 12, 2011, 08:07:48 AM

Best way I found to do front fork oil

http://www.gadgetjq.com/fork_oil_change.htm

Posted by Snow Drifter
 - June 11, 2011, 21:30:47 PM

Hey folks,
The front is sounding a little rattley and kind of springing on dirt/bumpy roads. What oil are you supposed to put in the shocks? It isn't leaking anywhere but I'm thinking the level may be low and I want to have some oil on hand before checking.
Thanks in advance for any info.
Snow

SMF spam blocked by CleanTalk