Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by chief
 - May 09, 2011, 15:05:45 PM

My double, way back in 2002 had a flat bar for the front instead of the horse shoe shaped bit on OEM solo's etc.

Supposedly you were supposed to install the corbin with that bar going under the "washer" deal on the bike... sorta use a scoop motion to get the seat bar under the washer. I could never get it to go in correctly... too far back, so I ground off a bit of the rear part of the washer/spacer so it would fit better and go on easier. It was hard getting the bolts in at the rear at first, but it got easier. Falls right into place now.

Mine had a plastic shield in the seat area between the seat and the rear fender. That has to be removed if its still on yours.

Posted by marshalldoll
 - May 09, 2011, 14:28:39 PM

Just a quick question because I am baffled. I purchased a tan Corbin solo seat for my 1500. It came right off of another 1500 and I have spent the better part of an hour trying to get it on but the seat attachment brackets just miss by a quarter of an inch which is like a hundred miles. I pushed and pulled but can't seem to get them to line up. I know Chief you have a 2 up Corbin and Troll you have the solo so could either of you give me some guidance.  Does the front mounting washer have to be lowered or removed to accomodate the Corbin?
Dan
dwclocks@aol.com

SMF spam blocked by CleanTalk