Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Drifter_Mal
 - December 10, 2023, 20:39:14 PM

Thank you for the input Genteman,

Can confirm the bike-down switch is in correct factory position held down by the battery clamp.

Given the bike ran only a few days ago I can't see how the clutch and/or kickstand switch could be suspects. Happy to defer to experience though.

I've got great spark going to the front cylinder, but I actually haven't tested spark in the rear. From my understanding spark in the front should be enough to have her run (albeit a bit rough). Can anyone confirm if the 1500 won't run without spark in both jugs?

Also yes, brand new high cranking battery.

Appreciate your input so far!

Mal

Posted by Troll
 - December 10, 2023, 17:52:33 PM

I would start with some new plugs. If the battery is even a little weak, they seem to flood. Had it happen to me several times, over the years.

Posted by chief
 - December 10, 2023, 14:53:50 PM

Make sure all the switches are in the proper position first (kill, clutch, kickstand, tip over).
I assume replaced the battery means a new battery. 

Posted by gwilki
 - December 10, 2023, 08:49:09 AM

When you removed, cleaned and replaced the battery, did you, by chance forget to mount the "fall over" switch correctly?

Posted by Drifter_Mal
 - December 10, 2023, 01:22:15 AM

Hello gentleman,

Looking for any kind of advice here.

Have a 1500 that has sat for the past two years, recently returned home to her and have started the process of recommissioning.

After repairing a cross-threaded spark plug on the rear cylinder (clutch side), I hooked up a car battery, turned ignition and she and she kicked into life without a whole lot of trouble.

Let her sit for a day and came back with new fluids, battery etc. After replacing oil, clutch/brake fluid & battery, cleaning and I tried to start her - no dice.

I've got a strong response from the fuel pump when ignition turns on, a strong spark on the cylinders and have a fully charged high cranking battery connected. She turns and turns but makes no attempt to start.

While I'm no professional I've got a good amount of experience on bikes and can't really think of where to check next. Any of the usual suspects seem to be well accounted for...

Any help appreciated!

Thanks,

Mal

SMF spam blocked by CleanTalk