Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Mike O
 - April 11, 2011, 07:12:36 AM

Thanks Gibby.  Makes sense to me.   

Posted by GIBBY
 - April 11, 2011, 06:51:57 AM

Hey Mike.
I had the same problem when I installed my RoadHouse Dooley's. I put a 1/2" spacer behind the bracket which moved it out. I do not remember if I had to replace the bolts. Be sure to use some blue locktite on all of those bolts because they WILL work themselves loose.

Posted by Mike O
 - April 10, 2011, 19:25:16 PM

[url]www.roadhousebrand.com/Merchant2/isheets/Kawasaki/56-165.pdf[url]

Here on section 5 last picture shows the bracket. 

Posted by Mike O
 - April 10, 2011, 19:11:39 PM

Question for those who have done this installation.   I'm about to instal the left side bracket to hold the muffler on.  Direct adding it to the frame make the bottom just about touch the rear wheel drive housing with out any weight on the bike.   It looks too close to me.  Sitting on the bike separates  the two plenty.    Did any of you run into this?   Did you make and modifications?

SMF spam blocked by CleanTalk