Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Last Edit: April 13, 2011, 14:52:37 PM by chief
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by TripWire
 - April 13, 2011, 09:22:18 AM

Yes I have the bike level on a lift (not on the kick stand) and I used the recommended filter.  Depending on where you find you information on the internet there are some people stating the Vulcan Classic 800 (not the Drifter) is a 3.2L not 2.9L.

When in doubt I will stick by the oilsite to determine if I have enough oil in the engine.

Posted by chief
 - April 12, 2011, 13:15:56 PM

Is the bike level... not on kickstand!? Did you use the recommended oil filter?  2.9L is the spec.

Posted by TripWire
 - April 10, 2011, 22:04:06 PM

Did my first oil change today.  The manual says 2.9L when changing the oil filter (who doesn't change their filter when changing the oil).  So I put in approximately 2.9L, ran the engine on idle for about 30 seconds and let her sit on the bike rack for about 15 min,  checked the oil sight and it's barely at the low mark.  Waited 15 more minutes and still barely on low.  I ended putting in about 3.4L in before the level was half way between low and full.  Does this sound right?  Is the manual wrong?

SMF spam blocked by CleanTalk