Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by chief
 - May 27, 2021, 16:57:06 PM

With the exhaust nuts(because of the crush gasket) you want to tighten them evenly and snuggly, but not over tighten. Since gaskets may vary, I tighten mine snug, until the gasket is crushed then use 61 in-lbs. I ride and check them again. Kaw mechanics have confirmed the 61 in-lb number according to some of our members. (I've heard 12-14 ft-lbs too... but I tend to be conservative and go with the lower number and work up. )

Anyway, that should get you started.

Posted by gwilki
 - May 27, 2021, 12:17:51 PM

I have the service manual. It shows torque settings for the two muffler bolts and even for the clamp that holds the heat shields on. It does not have a torque setting for the four nuts holding the pipes to the head.

Can someone please tell me what this setting is?

SMF spam blocked by CleanTalk