Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by mittico68
 - July 02, 2020, 11:36:27 AM

Well, I've got a 800 Drifter, but I think there aren't big differences in this case.
Each light is kept in by the rubber o-ring that you can see layin' around the plastic cover: it's in solidarity with the remaining part of each light housing that is under the dash plaque.
All you have to do is:
1- unscrew the 3 screws that hold in place the dash plaque (don't throw them away, because you'll reuse them for the new plaque);
2- gently widen said o-ring and simultaneously lift up the plastic cover, until it will pop up;
3- remove the light housing from the underside.
Obviously, you'll have to go through the above steps in reverse, in order to put on the new plaque.
Hope this helps.

Posted by Trall
 - July 02, 2020, 07:12:33 AM

What is the proper way to remove the three light housings to install in a new dash plaque on the 1500.

The dash lights are for high beam , turn signal and neutral.

I don't want to break them but since there twenty years old.

Bought a new Dash plaque

Thanks
Here the old dash plaque and new one pics

SMF spam blocked by CleanTalk