Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Bucko
 - June 08, 2020, 01:35:44 AM

Posted by ThinRedPaste
 - June 07, 2020, 20:30:26 PM

I did feel some clamps, but they didn't seem to be attached to the heat shield in any way.  They were tight, but the shield moved around separate from them, particularly the one toward the front.  Are they supposed to be permanently affixed to the heat shield and broke loose, or is there something on the inside of it that they clamp around and perhaps slid off of?

Posted by Troll
 - June 07, 2020, 20:26:12 PM

There is a clamp in the front, a clamp around the barrel shaped part where the rear cover attaches and 2 little silicon rubber dampers that slide over pins, and go into slots on the front of the muffler.

Posted by ThinRedPaste
 - June 07, 2020, 19:12:19 PM

Hey all, I just bought an 05 1500 Drifter (Had an 800 since December and decided it wasn't enough) and while getting it set up how I want and cleaning it up real nice, I found that the heat shield/cover over the middle part of the exhaust is basically just flopping around. 49107A looks to be the part number for the loose section.  I haven't been able to feel anything that seemed like it was meant to hold that in place aside from a little tab and slot deal back at the muffler, so I thought I'd ask here: How is that part supposed to be held on, and how do I fix it?

SMF spam blocked by CleanTalk