Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by badboy194
 - July 29, 2019, 14:18:50 PM

No sir it has the stock ignition.  The pump always started up when I turned the key on. I was going to give it to my Nephew as a gift when he returns this October from a year in Turkey.  He is USAF.  Dealer here won't work on anything older than 10 years. 

Posted by Troll
 - July 29, 2019, 10:54:44 AM

Do you have an aftermarket ign switch installed? The fuel pump will not turn on if the signal to the #25 (shows "unused" in the diagrams) is not correct. This prevents hot wire thefts. There should be power at the fuel pump connector on key up. The ECM grounds the other side of the pump to make it run. Once you determine which wire is which ( I don't have a j wiring diagram), then ground the non B+ wire with the key on, and the pump should run

Posted by badboy194
 - July 28, 2019, 19:39:01 PM

My 1500 Drifter set for @ 6 months.  Went to start it and fuel pump doesn't start up.  Cranks good.  Put new battery in and cranks hard. Lights all work. Bike is in neutral with clutch in or out no difference. Any suggestions? Thanks

SMF spam blocked by CleanTalk