Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by CDNRatMan
 - May 26, 2014, 12:53:45 PM

 Depending on were you live, check the shipping prices, also check partzilla.com and see what they charge for shipping.

Posted by bhus72
 - May 26, 2014, 12:15:16 PM

Thank y'all for the help, I couldn't find anything in my manual either but Trolls instructions and the diagram from ronayers.com were very helpful. I got all the disassembly done only to realize I did not order the correct replacements so I think the Ron Ayers link will pay off two fold. Thanks again

Posted by CDNRatMan
 - May 25, 2014, 22:02:20 PM

  ok I just spent the time looking through 3 manuals, and sad to say or I really need new glasses, but there is nothing about removal of the signal lights I could find......

Posted by Troll
 - May 25, 2014, 20:13:42 PM

It depends on what year your are working with. The blacked out ones are just a little different from the chromed ones. First, you remove the taillight assy. by removing the three 10mm nuts under the fender, then remove the two special plugs that connect the t'signals to the harness. Might be a good idea to identify which is left/right at this point...Pop off the big rubber cover over the nut on the signal side, and slide it down the wire and off. The plug will fit through, just barely. The signal assy is now loose and easily pulled out and away. The big difference between the black and the chrome is that the chrome ones have a cover over the fender stay that looks like a bumper, and you may feel that it's necessary to remove that, first...2 phillips screws hold them on....

Posted by bhus72
 - May 25, 2014, 19:19:03 PM

I am taking the originals off and replacing them

Posted by CDNRatMan
 - May 25, 2014, 17:55:09 PM

 Are you taking the original right off, or just replacing a part of them?

They are not that hard to take apart, you will need to get into the tail light to disconnect the harness however.

Posted by pcarrell
 - May 25, 2014, 15:29:54 PM

This should help!  http://www.ronayers.com/Turn-Signals-C383948.aspx

Posted by bhus72
 - May 25, 2014, 15:10:44 PM

I need to replace my rear turn signals but cannot figure out how to disassemble them, I feel like there is something small I'm over looking, but as a noob I figured I'd go to the experts. Any advice on the subject would be much appreciated.

SMF spam blocked by CleanTalk