We limit access by GUESTS to protect our members from spam, hacks and trolls. Please register to gain access to all our resources.
Posted by OR Seedman
- May 23, 2018, 11:22:06 AMOkay...so I have check the clutch switch...took it off and cleaned it with electrical contact cleaner, re-seated the connector, cleaned the starter switch and still nothing....neutral light is green, everything looks good....still nada....somewhere something is interrupting the connection between the starter switch and the starter itself....I guess I will start checking voltage and amps between the two when the starter button is pressed.....
Posted by OR Seedman
- May 23, 2018, 06:36:09 AMI will check that as soon as I get back to my research farm this morning....Since the neutral light is on, it most likely isn't the neutral switch down on the side....
Posted by mittico68
- May 23, 2018, 02:06:28 AMQuote from: greenbarn on May 22, 2018, 22:53:26 PMClutch switch perhaps? I know this switch has caused several people issues. I don't have the diagram in front of me, and it's been a while since I tried it - but I believe if I remember correctly, you can put it gear with the side stand down, and it runs until you let the clutch out -- so check out clutch lever switch.
GB, you're right.
The bike will run even with the side stand down and the gear ingaged, but you have to keep the clutch lever pulled.
Posted by greenbarn
- May 22, 2018, 22:53:26 PMClutch switch perhaps? I know this switch has caused several people issues. I don't have the diagram in front of me, and it's been a while since I tried it - but I believe if I remember correctly, you can put it gear with the side stand down, and it runs until you let the clutch out -- so check out clutch lever switch.
Posted by OR Seedman
- May 22, 2018, 19:14:15 PMNeed help...So today I rode to my research farm this morning. When I stopped to open the gate, I put the bike in neutral and put down the kickstand....and the bike just died...I made sure I was in neutral (indicator light is green) and push the starter button....nothing....I put the stand back up and down a couple of times and then moved in and out of neutral a few time, too. Finally, it started. However, when I went to head home this afternoon....nothing again...and no matter what I did to try and play with neutral and the kickstand...nothing. I can hear the injectors click when I press the started button...but nothing else. So, is it the neutral cut-off switch? Or?? Any help would be greatly appreciated...
OR Seedman