GUEST? Registration opens up many more resources which are not available to guests. Registration is free, we never sell or give others access to your information.
I have drained and cleaned both the rads on my 800's, used the water and whiter vinegar in both cases and as for refilling them not an issue, just let them burp and fill slowly to allow the air to escape, and check at the overflow tank, not hard.
If you're going to drain the cooling system anyway, pull the sensor out and bench test it to see if it needs to be replaced.
I have flushed both my 800 and 1500, had no issues, didn't have to do anything special to bleed them out.
I rode slowly through the down town section of a neighboring city only to have the high temperature light of my 2001 800 come on. The radiator fan was not running which helped isolate the issue. Removing the seat and fuel tank I checked the fuse then located the connectors for the fan and fan switch sensor. Bypassing the sensor, the fan ran well which isolated the problem to the fan switch sensor. This item from Ebay will be here this next week https://www.ebay.com/itm/RADIATOR-FAN-SWITCH-SENSOR-Fits-KAWASAKI-VN800-VULCAN-800-DRIFTER-1999-2006/281829373251?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649 so I should be back on the road shortly there after.
My plan is to drain the cooling system before I replace the sensor, then flush the system with white vinegar and distilled water before replacing the coolant.
Does anyone have sage advice with any or all of this project? Has anyone had issues with air getting trapped in the cooling system when refilling with coolant? Any pitfalls I need to look out for?
Page created in 0.064 seconds with 12 queries.