Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Ogri
 - April 24, 2018, 15:53:07 PM

Part of a non-return valve of some kind?

Posted by OR Seedman
 - April 24, 2018, 11:56:34 AM

so...I was changing the oil on my 1500 that I replaced the bevel gear bearing on  (first oil change after initial clean out and repair...about 250 miles on this oil) and I pulled the pre-filter screen to get everything out.  The screen was clean and I could not find any metal shavings from the bad bearing when I emptied the oil....however, I did find these two small ball bearings (3-4 mm in diameter).  Any idea where they would have come from internally?  they are far too small to have come from the bad bevel gear bearing and none seemed to be missing from it when I pulled it....any ideas would be greatly appreciated...

ps...the engine seems to run just fine without any excessive knocking or noise...

SMF spam blocked by CleanTalk