Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by CDNRatMan
 - April 16, 2018, 23:16:13 PM

 :o if you say so, then I have been misinformed.

Posted by Sparky1971
 - April 16, 2018, 19:28:36 PM

It's been done before :)

Posted by CDNRatMan
 - April 16, 2018, 00:05:57 AM

  Well you will not be able to run LED in the rear signal lights and regular bulbs upfront they need to be all one or the other.

Posted by Sparky1971
 - April 15, 2018, 21:31:17 PM

Ok, these are good suggestions, it was doing the same before attaching the rear lights, they are standard bulbs, looks like they were replacements with no running lights hooked up, 1156 bulbs.  The rear assembly is LED but there is no change, solid left and nothing on the right.  The inside of the turn signal does look pretty corroded, I may try to replace the front signals too or at least hook up some I have laying around to see if it would help.

Posted by Troll
 - April 14, 2018, 03:00:33 AM

Probably not the flasher. Get out your test light and check for power and ground where it's supposed to be. The connector block for the rear fender lights may have a corrosion problem, so take off the little black plastic cover and pull it apart. You might also want to check the fuses, while your at it. The front turn signals also serve as position lights, so which filament is lighting up?

Posted by Ogri
 - April 13, 2018, 17:41:37 PM

Are they regular bulbs or LEDs? Are your grounds all clean and tight? Bulbs clean at their bases? What wattage are the bulbs and what wattage is the relay rated at?

Posted by Sparky1971
 - April 13, 2018, 12:49:47 PM

Good afternoon;

I have just picked up a 1500 to help out the 800 I had already and I have an issue with it already.  So when I bought it there were no turn signals on the rear, just brake and running lights, the front right turn signal didn't work and the right lights up and stays solid.  I installed a new tail light, turn signal assembly and the left side lights up front and rear but does not blink and the right side does not light up or blink.  I am thinking the flasher relay has gone bad but would appreciate any input you may have on it also.

SMF spam blocked by CleanTalk