We limit access by GUESTS to protect our members from spam, hacks and trolls. Please register to gain access to all our resources.
Posted by Sparky1971
- April 15, 2018, 21:31:17 PMOk, these are good suggestions, it was doing the same before attaching the rear lights, they are standard bulbs, looks like they were replacements with no running lights hooked up, 1156 bulbs. The rear assembly is LED but there is no change, solid left and nothing on the right. The inside of the turn signal does look pretty corroded, I may try to replace the front signals too or at least hook up some I have laying around to see if it would help.
Posted by Troll
- April 14, 2018, 03:00:33 AMProbably not the flasher. Get out your test light and check for power and ground where it's supposed to be. The connector block for the rear fender lights may have a corrosion problem, so take off the little black plastic cover and pull it apart. You might also want to check the fuses, while your at it. The front turn signals also serve as position lights, so which filament is lighting up?
Posted by Ogri
- April 13, 2018, 17:41:37 PMAre they regular bulbs or LEDs? Are your grounds all clean and tight? Bulbs clean at their bases? What wattage are the bulbs and what wattage is the relay rated at?
Posted by Sparky1971
- April 13, 2018, 12:49:47 PMGood afternoon;
I have just picked up a 1500 to help out the 800 I had already and I have an issue with it already. So when I bought it there were no turn signals on the rear, just brake and running lights, the front right turn signal didn't work and the right lights up and stays solid. I installed a new tail light, turn signal assembly and the left side lights up front and rear but does not blink and the right side does not light up or blink. I am thinking the flasher relay has gone bad but would appreciate any input you may have on it also.