GUEST? Registration opens up many more resources which are not available to guests. Registration is free, we never sell or give others access to your information.
Sounds like your neutral switch was either damaged or the wiring to it damaged. I'll be honest, though- I've never had to locate mine, so not sure exactly where it is. Did the foot shifter get damaged/bent at all? Perhaps if it is hanging up on something a little the trans could be going into N, but not exactly to the point where it "makes" the switch.
Doesn't sound all in all like it's too awfully bad. Hope you can salvage her.
The machine is back in the garage, so spent some time with it today. Just giving you guys a sense of what I found post accident. Some thing I expected and other I didn't:
- burped the oil system by removing and reinstalling the oil filter
- found neutral, but neutral light not lit
- turned key and all the dash lights came on (except neutral light)
- engine would not crank until I pulled the clutch in
Note: Clutch is disengaging with the lever. That's how we moved it the night it came off the truck. It was still in gear from the accident.
- once I found pulling in the clutch lever would let it crank, I tied the clutch lever in(disengaged)
- pulled out the choke and cranked the engine. It cranked slow, but started right up
- all the dash lights went out (neutral light still not lit)
- headlight and turn signal lights were on. Spots did not work
Note: Judging by how bent up the bar was, my guess is bulb filaments got broken with the shock of the accident. Pulled the fuse, since I couldn't remember the switch position for "off"
- warmed it up thru choke cycle, then wedged throttle on a high idle and ran it in place for over 30 minutes. Engine warmed up, fan came on. No leaks or odd sounds. Everything normal.
- shut it down and fan stayed on, then cycled off as normal.
- pulled the bent up fire and steel engine guard off. Found the left side attachment bolt slightly bent, but it backed out. Easy to replace.
- removed the windscreen, which was undamaged. Mounting hardware bent forward though
- removed bent and broken aftermarket Honda CB chrome mirrors
Handle bars are the only other thing severely bent, but they can stay for now. Wanted to run the engine and remove enough of the damage to have a reasonable storage profile...now I can cover it again.
So the only thing that is not intuitive right now, is why the clutch lever has to be engaged for the engine to crank. I'm sure there is some permissive circuit that got compromised, like the neutral light circuit, which is not coming on even the bike is in neutral....may be telling the ignition circuit not to work, because it thinks the bike is in gear. Just my thoughts...always open to the thoughts of the group on any and all.
Thanks to Old Drifter for the lead on a pair of fork tubes....I am tracking the chop shops for bits and pieces. Also may consider a replacement since insurance settlement was favorable once I provided research on limited production and actual cost of factor accessories. Progressive my carrier with a rider for accessories. I think they were more than fair. Lawyers handling the medical bills and I've got a PT schedule thru the end of Feb.
That's it for now.
Page created in 0.081 seconds with 13 queries.