Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by sumgnuguy
 - August 23, 2017, 21:57:34 PM

Good day,
Basic but important questions.
I received new grips....ready to remove old clutch side grip for example. I see after unscrewing the chome end cap off the stock a threaded end.
This end sticks out longer than the new grip. About the entire length of the thread to be honest
The threaded end appears to be a part of the handle tube.
Do you all cut this off and be done with it or does it screw off?

While here, the throttle grip has the ferrule ends for the cable. It is not just a slide on cover.
I have learned to undo cable housing screws....correct....and fit?
The grips are throttle side 12.5cm and clutch side 11.5cm x 1" diameter.
Thanks[ :o
https://ibb.co/kM3nwk

SMF spam blocked by CleanTalk