GUEST? Registration opens up many more resources which are not available to guests. Registration is free, we never sell or give others access to your information.
Posted by Aimee.L
- July 12, 2017, 21:54:23 PMEnded up getting my valve clearance check and adjustment done. The petcock seemed ok but the bike now won't stay running with the petcock in the on position but will in reserve. Couple of odd things after the valve adjustment. My idle was a little bit higher, of course it could just be I hit it while doing every thing else. The second did thing is the valve clearances were quite a bit out and after adjusting them the motor now sounds kind of tinney to me now. I explained it to my husband as it used to sound like little galloping ponies and now sounds like sprinting tap dancers, lol 
Posted by Aimee.L
- July 12, 2017, 13:10:35 PMAny suggestions on this rear cover? I've tried every direction and can not clear the chain.
Posted by Aimee.L
- July 12, 2017, 10:01:03 AMNevermind got it YAY!!! Thank you soooooo much!
Posted by Aimee.L
- July 12, 2017, 09:57:51 AMwhat's the best way to greet the tube to stay down without damaging anything. I think that's what I'm stuck on now.
Posted by CDNRatMan
- July 12, 2017, 09:17:28 AMOk valve check is fairly simple, the hardest part is removing the cover on the rear cylinder, just have to be patient and slowly ease it and wiggle it out. Hardest part is if the spark plug tube stays with the valve cover it should remain down. At the time doing the valve check would like you figure a great time to check out the tank and all the hoses and lines to be sure they are kink free and not pinched anyplace. You can also check all your grounds under the tank and wiring. Have fun and enjoy tinkering.....
Posted by Aimee.L
- July 11, 2017, 23:03:22 PMI was glad to see 2 stores in town carry it here.
Update : tomorrow I'm gonna take a whack at doing my valve check, also grabbed new plugs and a new K&N filter. At the same time I'll check my petcock and get to see what the current air filter looks like. Once it's done I'm gonna add the seafoam to the gas tank and see if that helps. I'll add seafoam to the oil when I'm due for an oil change. I'll see where that gets me and reupdate.
Posted by UGLY
- July 11, 2017, 22:03:30 PMGood to see Seafoam. We finally got it in Canada.
Posted by CDNRatMan
- July 05, 2017, 22:38:55 PMvalve check should not take you long to do that and then get the other issue sorted out......
Posted by Aimee.L
- July 05, 2017, 22:26:18 PMActually now that you say that I think I remember reading the same in the manual. I don't fill it into the neck but I fill it close. So possibly except for I made it much more than a few miles both times. 80ish miles the first time and 60ish miles the second time. It's just about due for valve check so I'm gonna send it in and have them tasks a peek at it as well as pick up some seafoam and see where I'm at.
Thanks a bunch, I knew I could count on this forum for plenty of info. ❤
Posted by 2beers
- July 05, 2017, 19:33:42 PMWhen we got our first Drifter, the PO made a point of telling us not to 'overfill' the tank at the gas pump (blocking the filler neck vent). He said it would stall without notice after about 3 miles if we did. Hope the answer to your stalling issue is this easy!
--The Bride
Posted by Aimee.L
- July 04, 2017, 16:05:30 PMAwesome, will try. Thanks. 
Posted by CDNRatMan
- July 04, 2017, 16:01:06 PMAlso add 2 "glug"s of seafoam and go for a ride and see what happens, if there is any dirt or such in the system this should clean it up.
Posted by Aimee.L
- July 04, 2017, 12:42:50 PMMakes sense. I'll check the hose as well and keep my progress updated. ☺
Posted by Troll
- July 04, 2017, 12:03:44 PMFuel tank vent/hoses. With a gravity feed system, if the tank doesn't vent to the atmosphere, the fuel will eventually pull a vacuum in the tank and that will cause the engine to stop running. I had this exact thing happen to me when I first got my W-650. Fuel tank vent hose was kinked under the tank. Found that and it hasn't happened again since 2009
Posted by Aimee.L
- July 04, 2017, 10:42:46 AMI was pretty convinced it was some kind of fuel issue but now that you mention the kill switch I remember it acting finicky like a loose connection or just going bad. I'll try checking there first. Thanks
Usually I do pretty good detective work, lol. If I can replicate the problem. Right now im at that annoying stage of its happend but not quite enough to narrow it down.
Also for the other info:
The previous owner traded it in in May and I bought it within a week of it arriving at my husbands work so I'm not sure about his winter storage but judging by his meticulous service records he turned in with the bike I imagine he probably stored it properly. I'll work down the fuel system list after I get the kill switch checked and/or replaced and I'll update this post as I go. Thanks again.