Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by drifter-paul
 - July 05, 2017, 21:33:24 PM

Am about to change wheel bearings, and found this handy/cheap method on youtube. Copy and paste the address below into your search field, there is also a link down the bottom right of the video to get a longer version.

It uses a 20mm Anchor bolt (masonry plug/rawplug) 120mm long - you can see similar in the video - not sure what you call them.

I tested it first on an old bearing , a mate had lying around. At first I thought the video man must have used an Imperial  3/4 inch. The bearing i.d. is 19.97 mm on my vernier and the mushroom head of the bolt slides in with a little leeway. The expanding collar wouldn't fit thru by hand, but a few taps with a wooden mallet and it slipped in. My bolt is by Ramset and has two collars. I removed the plain nut-end collar to get room to hold the bolt by the thread while tightening the nut.  8)

Had problems trying to put the link here. So amend the following - youtube.com/watch?v=t7VQnNfqJtA

SMF spam blocked by CleanTalk