Modify message

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by CDNRatMan
 - June 05, 2017, 17:05:22 PM

this has been done like this....

Posted by ranxerox
 - June 05, 2017, 16:16:29 PM

I put in a tool bag where my regulator was, but now I'm having trouble getting my kickstand down; there are no custom kickstands for the Vulcan models.  My thoughts are as follows:

1) buy a casting and bolt it to my kickstand foot to allow my foot to catch and pull down the kickstand, or
2) cast an object with nuts already embedded.

Either way, I would have to drill out 2 holes in the foot and put in a couple of flush mounting SS bolts from the bottom.

My question is would this hurt the kickstand?

I wouldn't be opposed to putting in some JB Weld to hold it all together.

I'm open to thoughts, ideas, alternatives...

SMF spam blocked by CleanTalk