Post reply

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by chief
 - October 18, 2010, 11:36:11 AM

OEM levers?

Oem levers have a dial for adjusting the distance between lever and bars... on vulcans the friction zone is always very close to the release point - farthest from the bar. If you aren't getting any clutch until up close to the bar, you have a problem... either the hydraulics - air/low fluid, etc... or clutch plates - wear etc.

Posted by kiwisteve
 - September 30, 2010, 13:52:06 PM

Hi All. anyone have any tips on replacing the head pipe outer race removeal. Don't have the Head Pipe race remover tool part # 57001-1107. How did you manage to get the outer race out?

Hi All, update. Finally found a gear puller that worked, had one at work. The end that grips the outer case bearing needs to be sharp to fit into the gap between the Head Pipe and the bearing. To install bearing I used a large socket and tapped them in nice and tight. All back together now. Found a problem with the clutch, the lever hits the grips every time and are unable to bleed the clutch? Next project.

SMF spam blocked by CleanTalk