Post reply

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by Troll
 - August 01, 2014, 18:39:43 PM

I'd replace it if I were you. That's where it goes, but if it got out of its groove, then it's damaged

Posted by Bucko
 - August 01, 2014, 16:19:53 PM

I'm in the middle of a tire change and decided to pop the rear gear case off the swing-arm to grease the input shaft splines.  I noticed when I pulled it off that there was a O ring floating on the shaft between the back of the gear case and the splined part of the saft.  There looks like a pretty big U shaped grove just behind the splined part - is that where the O ring is supposed to go?  Is is supposed to seal the grease into the 'socket' that the splined part of the rear case fits into?  I believe the O ring is  92055c on the fiche:

SMF spam blocked by CleanTalk