Post reply

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by chief
 - March 28, 2010, 20:08:48 PM

Drill the bolt and use ez out

Posted by motosickle
 - March 28, 2010, 19:54:37 PM

if it were mine...... i'd drill out the existing nut, remove the rest then pull the exhaust system. then you can use a stud removing tool. you might want to heat the stud area before turning. then replace the stud and get new nuts

Posted by 1999 Drifter
 - March 28, 2010, 16:29:01 PM

Ok, went to remove my exhaust nuts and the rear exhaust nut closest to the cylinder of course is rounded (inside), there are no edges for the allen key to grab. Ive tried heating etc with no results. I had to buy an over the nut easy out for the others, but there is no room for this to slip over the nutas it's to close to the rear cylinder.

I need help!!!!!!!!!!

Just one of the little(big) things to watch out for when buying your used motorcycle....check the nuts to make sure they are not rounded, could cause problems for you down the line

SMF spam blocked by CleanTalk