Post reply

The message has the following error or errors that must be corrected before continuing:
Warning: this topic has not been posted in for at least 180 days.
Unless you're sure you want to reply, please consider starting a new topic.
Attachments: (Clear attachments)
Restrictions: 6 per post (6 remaining), maximum total size 64.00 MB, maximum individual size 29.30 MB
Uncheck the attachments you no longer want attached
Click or drag files here to attach them.
(Clear attachments)
Other options
Shortcuts: ALT+S post or ALT+P preview

Topic summary

Posted by jveley
 - April 09, 2011, 10:49:11 AM

I had a thought when I was putting LEDs on the front for flashers to put 2 pairs of regular bullet flashers on the back to pull the amps up high enough.   After I got one set on, though, I thought a second set would be too much.   Besides, I kind of like the faster blinking.

The headlight can is so big, you might also wire some "hidden" signals inside the can, but that seems like a lot of work to get out of using the load resistor.

Posted by griz01
 - April 09, 2011, 08:29:16 AM

Has anyone successfully wired an electronic flasher into the Drifter? My LED's are flash too quickly and I am trying to avoid splicing in any resistors.

SMF spam blocked by CleanTalk