Vulcan Drifter Riders

DISCUSSIONS => Drifter 800 Only => Topic started by: Kiwibob on October 25, 2020, 03:23:15 AM

Title: 900 to Drifter conversion
Post by: Kiwibob on October 25, 2020, 03:23:15 AM
Has anyone heard of swapping out a 900 swingarm with a 800? I thinking the pivot connexion should be the same and the only difference is the width at the axle as the 900 is wider for the belt.
I guess some may ask why. I have only seen one 800 drifter for sale here (NZ) and was a few years back. Very rare beast. 800 vulcans are also few & far between Only option I can see is a conversion to my 900 classic. I have the fenders & all chromework but the rear swing arm is too wide for the fender.
Is there a tech thread regarding dimensions of swing arms/rear wheel hub etc

thanks in advance
Bob
Title: Re: 900 to Drifter conversion
Post by: chief on October 25, 2020, 11:40:50 AM
Interesting proposition. I haven't heard of such a conversion. Studying the rear ends would be a good starting point.
Title: Re: 900 to Drifter conversion
Post by: Kiwibob on October 25, 2020, 13:25:29 PM
Thanks Chief.
Im hoping someone with an 800 might be able to give me an overall length of the swingarm pivot connexion (without pin) so I can decide if I buy a swingarm.
I see Ebay are not posting from US at the moment......

Bob