front end wobble

Started by michaelh42, September 15, 2011, 19:14:38 PM

Previous topic - Next topic

michaelh42

Thanks for all the info. The tire is fairly new so I will work on the other areas first. not saying the tire isn't bad just new. still enjoying the ride just a little colder in the morning now  :o


49Reo

There are a few areas where a vibration or wobble can be felt on deceleration; to name a few, tires out of balance or separating, steering neck bearings, or wheel bearings; check these out first, starting with tires, the usual culprit.
Good luck on your Gremlin Hunt;
Regards and such, 49Reo

Location: B.C., VDR#: 666
02 Drifter 1500, 02 Softail Frankenstein Trike.."Beauty" and "The Beast"

"If you don't believe your country should come before yourself, Ya can better serve your country, by living somewhere else."  In memory, Stompin' Tom Connors
RIP

badboy194

#3

Chief is right about the tires.  The cupping or wear of the tires usually makes the wobble.  That is not to say front end maintenance should not be checked.  When you apply power the "Gyro" action seems to mask the wobble, but on coasting it is noticeable.  It does not seem to affect the narrow front tire bikes the same way.  I have had that problem with 9 different bikes and new tires fixes it every time.


chief

mileage?

Front-end wobble is one of those things that occurs on many bikes for many reasons. On the drifter it is often because of cupping tires, front and/or rear. However, it can be bearings, rim/spokes as well. Make sure you have done your front-end pm's.
Slainte mhaith - Good Health - Cheers

'02 Vulcan Drifter 1500

michaelh42

I have notice a "wobble" in the front end from about 38 to about 32 mph only when I slow down. there is maybe a slight shake when accelerating but it is hard to tell. I have not made any changes to her and I have newer tires and brakes. I have put about 3k on the bike before I noticed this. I am concerned this is going to get worse or something is going to break... any ideas? I have tried the bearing on the fork and it seems ok but I am no expert.


SMF spam blocked by CleanTalk